H Bridge Motor Control
Given below is an H bridge motor control and driver circuit using IC L298
A bidirectional H bridge DC motor control circuit is shown here. The circuit is based on the IC L298 from ST Microelectronics. L298 is a dual full bridge driver that has a wide operating voltage range and can handle load currents up to 3A. The IC also features low saturation voltage and over temperature protection.
韦德体育投注网是什么,韦德体育appIn the circuit diode D1 to D4 are protection diodes. Capacitor C2 is the logic power supply filter and capacitor C2 is the supply voltage filter. The state of the motor will depend on the logic level of the pins 10, 11, 12 and it is described in the table shown below the circuit diagram.
Circuit diagram of H bridge motor controller:
- Do not connect a motor that consumes more than 2.5A of current.
- The main power supply can be anything between 3 to 40V DC.
- It is advised to fit LM298 with a proper heat sink.
We have more articles of your interest related to H-Bridge:
Other Motor related circuits in our website: